In our daily use of UV flatbed printers, there will be more or less failures, which are unavoidable, and there will be some problems with the parts of the machine during long-term use. Maishengli will share with you that the XYZ axis of the UV flatbed printer cannot be reset and the solution. The X axis refers to the abscissa direction of the device, the Y axis refers to the vertical coordinate direction of the device, and the Z axis refers to the height direction of the device.
What is the reason why the XYZ axis of the uv flatbed printer cannot be reset?
一、 The XY axis of the uv flatbed printer cannot be reset
1. If the limit exceeds the limit, the solution is to push it back to the trolley of the equipment;
2. The emergency stop switch is not turned on, the solution is to open the emergency stop switch;
3. The single drive is powered off, the solution is to power on again, if it is damaged, replace the new single drive;
4. The drive and power supply are damaged, the solution is to replace the new drive and power supply;
二、The Z axis of the uv flatbed printer cannot be reset
1. If it exceeds the limit or is stuck, push the z-axis to return to the limited range;
2. If the communication is abnormal and the optical fiber is damaged, the solution is to replace the new optical fiber cable;
3. The motor screw joint is loose, the solution is to click the screw interface to tighten it again;
4. The motor driver is in poor contact. The solution is to tighten the lower motor driver interface.
5. The driver signal line is loose, the solution is to tighten the interface of the driver signal line.
Precautions
The failure of the XYZ axis of the uv flatbed printer to reset directly causes the machine to fail to print normally. What needs to be distinguished is that the faults of the XY axis are the same, but the reason why the Z axis cannot be reset is different from the XY axis.
Post time: Sep-24-2022